system/lirc: Updated for version 0.8.4a

1 files changed, 43 insertions, 0 deletions

diff --git a/system/lirc/README.SLACKWARE b/system/lirc/README.SLACKWARE
new file mode 100644
index 0000000000..41cbd33bbd
--- /dev/null
+++ b/system/lirc/README.SLACKWARE
@@ -0,0 +1,43 @@
+lirc README.SLACKWARE
+
+===============================================================================
+
+Configuring lircd (the LIRC daemon)
+
+ 1. Check if there is already a config file in /etc/lircd.conf. If not,
+ 2. Check if there is a config file available for your remote control at 
+    the LIRC homepage and if so, copy it to /etc/lircd.conf. If not,
+ 3. Start irrecord (close all applications that access /dev/lirc first) 
+    and follow the instructions given to you by this program.  Copy the 
+    resulting file to /etc/lircd.conf.  If you have trouble creating a 
+    working config file, please read the chapter about adding new remote 
+    controls -- http://www.lirc.org/html/help.html#new_remote
+
+Q: How can I use the infrared remote shipped with the tv card ?
+
+In the 2.6 kernels the remote simply is registered as keyboard input device 
+within the linux input layer. When using the saa7134 driver it "just works", 
+with bttv you'll have to load either ir-kbd-gpio or ir-kbd-i2c depending on 
+your TV card. If in doubt just try both. Have a look at /proc/bus/input/devices 
+file to see whenever the device is present or not.
+
+With the driver loaded the IR just works like a additional keyboard. The numbers 
+are mapped to the keypad keys. Depending on the X-Servers keyboard configuration
+(try to pick a multimedia keyboard) other keys like the ones for volume control 
+might work too.
+
+Q: But I want use lircd for IR input.
+
+No problem, you can do that too:
+
+  1. Get a recent lircd version with linux input layer support. The 0.6.6 
+     release is too old, a cvs snapshot or a 0.7 pre-release should do. You
+     only need to build the lircd daemon + tools, no lirc kernel drivers 
+     needed. Take care that the dev/input driver is included when building 
+     lircd (either ./configure --with-driver=any to simply include all drivers
+     or --with-driver=devinput).
+  2. Load the evdev module (which is part of the linux input layer). Check 
+     /proc/bus/input/devices to see which eventn device the IR input device has.
+  3. Start the daemon this way:
+    /usr/sbin/lircd -H dev/input -d /dev/input/eventn. 
+